Products

MODEL 214 STRAIN GAGE BRIDGE CALIBRATOR

Description
The Model 214 provides AC calibration to a strain gage bridge. It will switch a parallel CAL resistor across any leg of the bridge at the selected frequency. The desired CAL resistor is selected using the front panel decade
resistance thumbwheel. Any resistance from zero ohms to 9.999 Megohms is selectable in steps of 1K ohm. A front panel LED is provided as a power on indicator and a low battery indicator. If the battery voltage falls below 15.0 volts the front panel LED will go out. The batteries are located in
a rear panel compartment for easy access.


Specifications

Bridge: 120 ohm to 1K ohm


Bridge excitation: .5 volts to 10.00 volts, +P to - P


Frequency: Switch selectable at 10, 20, 50, 100, 200, 500, 1kHz


CAL resistor: Adjustable from zero ohms to 9.999 Megohms in 1K ohm steps
with ± 1% accuracy


Output: FET switch closure in series with CAL resistor


Indicators: Combined front panel Power On/Low Battery


Power: Operates on two 9V batteries, Eveready #505 or equivalent; eight-hour continuous operation


Operating
temperature:
-25° to 140°F


Rear panel
connectors:
Monitor banana jacks; output BNC


Mechanical: High impact plastic instrument case 4.5”W x 8.75”D x 3.5”H



Terms & Conditions  Privacy Statement  Site Map
® 2007 Encore Electronics All Rights Reserved